MTX Audio MP42B/ MP42W User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
5
MP42 CONFIGURATION GUIDE
BOOKSHELF
Remove the B-Style end caps, brass thumb screws, and
aluminum mounting bracket. Replace the brass thumb
screws in each end of the cabinet and snap A-Type end
caps into place. Then simply place the self adhesive cabinet
feet in the appropriate locations to protect the MP42 cabinet
and whatever surface that it will set on.
A-TYPE
CAP
A-TYPE
CAP
SELF ADHESIVE
CABINET FEET
10
WIRING
Connecting the Speakers to Your System
Though there are many sizes of speaker wire available.
MTX recommends using 18 gauge or heavier wire to
connect your loudspeakers to your amplifier or receiver.
Before cutting the speaker wire to the proper lengths, be
sure to leave an extra two or three feet of surplus wire, just
in case you have to move the components around. Using
a wire cutter or sharp knife, strip off about half an inch of
insulation from both ends. Twist the exposed wires to make
them easier to insert in the speaker terminals. Make sure
that you unplug your amplifier or receiver before proceeding
any further.
When using the MP42 as a center channel or surround
speaker follow the hook-up directions included with your
surround processor.
It is essential that you connect your two speakers “in phase”.
To do so, first take note of the code used on the speaker
wire to differentiate between the two wires that run through
it.
To wire your speakers in phase, make sure the positive (+)
terminals on the back of your receiver are connected with
the red terminals on the back of your loudspeakers, and the
negative (-) terminals on the receiver are connected with the
black terminals on the speakers (see diagram). Note that
negative (-) terminals on the receiver may also be marked
“common” or “ground” (GND).
Be certain that no stray strands of wire cross from one
terminal to another on either speaker or receiver. This could
result in a damaging short.
+
-
+
-
+
-
RED
BLACK
RED
BLAC
K
REDBLACK
LEFT RIGH
T
Page view 5
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments